MARTIN® SPRAY Dust Suppression System uses dual spray bars to apply water directly to the material stream to provide dust control without containment.

The spray bar system operates at facility water line pressure and is activated using a 110/120V control signal. The spray bars are used in applications where containment is not needed or desired. (A traditional fog system should only be applied in situations where containment was provided.)

By strategically wetting the material as it moves through the transfer, the potential to create dust is eliminated.

Two Spray Bars

Dual system treats both top and bottom of material stream. Outer nozzles on each bar swivel to prevent overspray.

Accommodates “Dirty” Water

Large 0.094” (2 mm) equivalent orifice nozzles and galvanized fittings accommodate plant water with large suspended particles or high/low pH.

Flexible Installation

Unistrut and Hose Clamp Mounts allow installation with or without chute wall.

Simple Plumbing

Garden Hose or 1” NTP makes tie-in easy. Manual ball valve allows isolation.

110V Solenoid Valve

Optional control with a PLC or in tandem with another component (such as conveyor drive pulley).

More Information

• Ask a question about MARTIN® SPRAY Dust Suppression System
• Request a price for MARTIN® SPRAY Dust Suppression System
• Order Literature for MARTIN® SPRAY Dust Suppression System
• Request a printed manual for MARTIN® SPRAY Dust Suppression System
• Print this page